Facility Engineering Review & Safety Inspections
Although you might not be in the market for a new or reconfigured material handling system there is always a need to implement a good safety inspection program of your existing equipment. In most cases, catastrophic events like the ones pictured on this page can be prevented if detected early. We have staff members with a trained eye for identifying these failure causing areas and with early detection can prevent these failures from occurring. We provide an extensive Facility Engineering Review & Safety Inspections written report that documents every area of concern. This report typically includes a photo of the concerned area along with a recommend plan of correction. The report includes a 36 item check list for items such inspection of plumbness and clearances, uprights with bent post, twisted uprights, damaged beam connector plates, check beam safety locks, etc. Report will also include recommendations for load placards, safety equipment, rack repair & replacement, and protection products to prevent further damage to existing equipment. These Facility Engineering Review & Safety Inspections can be setup based on a one time visit or periodic schedule.
Failure to implement such a plan could cause major cost for repairs, recovery and even death of employees.